Practical selection notes

Technical resources that lead to a decision.

Use these short guides to choose a route, plan a trial or isolate a failure. Each article links back to the relevant applications and products.

Selection guide

Selection guide 4 min read

How to Choose Water-Based PSA for Film Labels

Film label PSA selection starts from facestock, liner, target surface, coating method and the required balance between holding and removability.

Decision question Does the label need removable, semi-removable or permanent holding?

Read technical note

Selection guide 5 min read

Water-Based Flocking Adhesive Selection by Substrate

Flocking adhesive selection changes when the substrate moves from paper or ABS to flexible PVC, PP, PE, metal or glass.

Decision question Which surface treatment and adhesive route fit the actual substrate?

Read technical note

Selection guide 4 min read

Color Box Adhesive Selection for Paper Converting

Color box adhesive selection depends on paper surface, lamination, box structure, application method, open time and final bonding target.

Decision question Which paper surface, box structure and gluing process are causing the failure?

Read technical note

Process control

Process control 4 min read

Textile Coating Emulsion: Fabric, Coating Weight and Drying Window

Textile direct coating performance depends on fabric construction, coating weight, drying condition, additives and the buyer's final test method.

Decision question Which trial variable is changing film formation, hand feel or water response?

Read technical note

Process control 4 min read

Flocking Adhesive Film Thickness and Open Time

Flocking adhesive film thickness and open time affect fiber anchoring, surface feel, drying speed and failure risk after rubbing or aging.

Decision question Is flock loss coming from too little film, a missed open-time window or incomplete drying?

Read technical note

Testing method

Testing method 3 min read

Why Removable Adhesives Need Dwell-Time Testing

A removable adhesive can look acceptable in a short test and still change after storage, heat exposure or long dwell time on the final surface.

Decision question Will removal remain acceptable after the real storage and dwell period?

Read technical note

Testing method 4 min read

How to Test Protective Film Adhesive Residue

Protective film residue testing should use the real protected surface, defined dwell time, removal method and visual acceptance standard.

Decision question Is the mark adhesive residue, a surface ghost mark or actual surface damage?

Read technical note

Testing method 4 min read

Mosaic Backing Adhesive: Why Soaking Test Matters

Mosaic backing adhesive should be checked after soaking because dry sheet stability does not always predict whitening, mesh release or tile fall in wet-area use.

Decision question Will the backed sheet remain stable after water exposure and downstream processing?

Read technical note

Troubleshooting

Troubleshooting 4 min read

Why Metal Flocking Adhesive Fails After Heat Aging

Metal flocking failure after heat aging may come from surface contamination, oxide layer, film thickness, drying condition or the final service environment.

Decision question Did the adhesive fail, or did contamination, oxide or drying create the weak interface?

Read technical note

Claims & documents

Claims & documents 3 min read

Low Odor vs Low VOC in Flooring Adhesives

Low odor and low VOC are not the same claim. Flooring adhesive discussions should separate sensory odor, available documents and project acceptance requirements.

Decision question Is the project asking about sensory odor, a VOC limit or a specific document?

Read technical note

Need product data or a sample?

Use the article to define the next test.

Then send the substrate, process, failure and required documents through the sample request.

Prepare sample request Ask a technical question