High-tack application direction
Product codeAC-5406
High-Tack PSA Emulsion
Water-based high-tack PSA emulsion for film packaging, decorative materials and surface protection film applications.
Application fit highlights
Why evaluate AC-5406 for your application
Useful where substrate wetting is difficult
Requires customer-side storage and removal tests
What this product is for
AC-5406 is a high-tack water-based adhesive direction for protective films and decorative materials where substrate wet-out and initial holding need special attention.
This page is written for application screening and sample discussion. Final performance should be confirmed with the buyer's substrate, process route, test method and acceptance standard.
Suitable applications
- Protection film
- Decorative materials
- Film packaging
Suitable substrates
PVCPETBOPPLow-surface-energy plastics
Screening information
Only application-facing screening information is listed here. Detailed ranges and final product data should be confirmed by TDS and sample testing.
Product familyWater-based high-tack PSA emulsion
Application directionProtective film, decorative materials and film packaging
SubstratesPVC, PET, BOPP and selected low-surface-energy plastic surfaces
Data boundaryFinal tack and holding balance must be confirmed with the buyer's substrate
Process notes and first trial checks
Check whether the project needs high initial tack, long-term holding, removable behavior or a balance of these targets.
Review surface energy, surface texture, plasticizer risk and storage condition before choosing the sample route.
Confirm drying temperature and coat weight because high tack systems can behave differently after aging.
Frequently asked questions
What applications is AC-5406 High-Tack PSA Emulsion suitable for?
AC-5406 High-Tack PSA Emulsion is positioned for Protection film, Decorative materials, Film packaging. Final suitability should be confirmed with the buyer's substrate, process and test method.
What information is needed before requesting a sample or quote?
Please provide substrate, surface treatment, coating or bonding method, drying or pressing condition, current failure mode, target test and required documents.
Can Mengze provide TDS or SDS?
TDS or SDS support can be provided after the application route and document need are confirmed.
Common failure modes
- Insufficient wet-out on decorative film or textured material
- Holding loss after heat or humidity aging
- Removal difficulty when high tack is used on sensitive surfaces
- Adhesive transfer caused by substrate compatibility issues
Sample request checklist
- Decorative material or protective film structure
- Target surface and surface treatment
- Need for tack, holding or removability
- Aging and storage condition
- Current failure: lifting, transfer, residue or poor wet-out
Related product comparison
Compare with FL-5068 when removable performance is more important than high tack.Compare with AC-5309H when film label appearance and permanent bonding are the main targets.
Related applications
Related technical resources
How to Test Protective Film Adhesive Residue
Protective film residue testing should use the real protected surface, defined dwell time, removal method and visual acceptance standard.
How to Choose Water-Based PSA for Film Labels
Film label PSA selection starts from facestock, liner, target surface, coating method and the required balance between holding and removability.
Related products
FL-5068 Water-Based Removable Film Adhesive
Water-based removable adhesive for protective film, removable labels and temporary positioning where peel growth and residue must be checked under real use conditions.
FL-4561 Water-Based Semi-Removable Film Adhesive
Water-based semi-removable film adhesive for labels that need stronger holding than light removable systems.
AC-5309H High-Performance Film Label PSA
Acrylic emulsion for higher-grade film labels and fine label printing applications.
Request sample, quote or TDS
Send your substrate, coating method, current bonding problem and target test method. We can suggest a sample route before sharing detailed TDS or SDS.
Include these details
- Decorative material or protective film structure
- Target surface and surface treatment
- Need for tack, holding or removability
- Aging and storage condition
- Current failure: lifting, transfer, residue or poor wet-out