Run the actual print-and-release cycle
Platen Printing Positioning Adhesive
Platen-printing positioning adhesive needs enough hold to control fabric movement while still allowing release, cleaning and repeatable use on the actual printing table or carrier surface.
Application requirements
What the adhesive route needs to handle
Controlled positioning holdRelease without unacceptable transferCleaning-cycle compatibilityRepeatable behavior during production
Common substrates
TextilePrinting table surfaceCarrier filmSelected process surfaces
Common failure problems
- Fabric shifts during printing
- Excessive tack
- Adhesive transfer or residue
- Holding drops after cleaning
- Uneven coating
Selection logic
Start with the use case, then narrow the route by substrate, process window and failure mode.
Table or carrier materialFabric constructionApplication methodProduction interval and heatCleaning method
Recommended product routes
- AC-5305D for platen-printing positioning trials after the hold, release and cleaning targets are defined
Sample request checklist
- Printing process and table surface
- Fabric type
- Application method and coating amount
- Hold and release target
- Cleaning method and cycle count
Testing suggestions
Record coating amount and recoating interval
Check movement, transfer, residue and cleaning over repeated cycles
Recommended models
Request a sample for this application
Send us your substrate, coating method and current bonding problem. We will suggest a sample route before sending detailed TDS.
Information to include
- Printing process and table surface
- Fabric type
- Application method and coating amount
- Hold and release target
- Cleaning method and cycle count